60W 40KHz Ultrasonic Piezoelectric Cleaning Transducer for Ultrasonic Cleaner
Ultrasonic vibration head mounting process
First, preparation tools: argon arc welding, hex wrench No. 10, ferrochrome wire, 2.5 square high temperature line,
2*2.5 cable cable, vibrator glue, (stripping pliers, casing, cable ties, sand blasting machine, pipe fittings, etc.).
Second, the welding screw: Calculate the position of the vibrator, weld the screw in the cleaned position, and then clean the screw around, be sure to make it flat, so as not to affect the installation of the vibrator.
Third, the glue configuration: the glue is stirred evenly according to the specified ratio. (Merray, Araldite, 4030 glue before mixing, KMD398 glue mixed during bonding).
4. Install the vibrating head: Spread the glue evenly on the bottom of the ultrasonic vibrator, and gently squeeze the air and excess glue between the bottom of the transducer and the contact surface of the cylinder to squeeze out the vibrator and the stainless steel as a whole. .
5. Curing and solidification: It is solidified at a relatively high room temperature, and can be connected in 4-8 hours. After 24 hours, the test machine can be energized. The test machine is absolutely not allowed to be air-vibrated.
Note: 1. Metal nailing machine can also replace argon arc welding.
2, the welding screws must be fully welded, otherwise it will fall off easily.
3, on the curing, the length of time should consider the temperature, the temperature is low for a long time, the temperature is high, it is faster, it is recommended to operate at room temperature, even if heated, do not overheat, appropriate.